Phone Library
Samsung R211
Programming Instructions
- Power the phone on
- Enter ##626*
- Enter 000000 or 141887, 333333
- Enter in 10 digit MDN number followed by OK
- Enter in 10 digit MIN number followed by OK
- Confirm that the SID number is correct followed by OK
- Scroll to done and use left soft key to exit
- Phone will power cycle and programming is now complete
Diagnostic Mode
- No diagnostic mode required.
Additional Troubleshooting
- Make sure phone is in diag mode. (if applicable)
- Ensure port on phone is clean, brush out if necessary.
- Check for proper cable and snug connection to phone port.
- Unplug computer side of USB cable, wait 3 seconds and plug into different usb port.
- Reinstall drivers for your mobile device. Use Device Manager to ensure you dont have any driver conflicts and the phone is showing up properly.